SEAT Workshop Service and Repair Manuals

Removing and installing exhaust gas temperature sender 1 -G235- t  Removing → Anchor t  Fitting → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Wrench kit -3337-, see equivalent → Anchor

t  Wrench kit 17 mm -T10395-, see equivalent → Anchor t  Plug set for engine -VAS 6122-, see equivalent → Anchor

Removing –  Unfasten quick release fasteners -1 ... 3- and detach noise insulation (front and rear).

–  Disconnect connector -3- on exhaust gas temperature sensor 1 -G235- and expose below engine block. –  Remove clip for fastening line on exhaust gas temperature sensor 1 -G235- between starter and engine block.   Note -Items 1 and 2- can be disregarded.

–  Remove engine cover panel -arrows-. –  Remove air cleaner housing → Chapter.

–  Disengage the connector -3- of the Lambda probe -G39- and move the electric wiring clear. –  Screw out the Lambda probe -G39--1- using the wrench -3337/1-. –  For safety reasons, insert a sealing plug -VAS 6122- in the opening of the Lambda probe -G39-.

–  Remove the exhaust gas temperature sender 1 -G235--1- using the 17 mm wrench -T10395/7-. –  Expose electrical line -arrow-. Installing Reassembly is carried out in the reverse order; note the following:   Caution Attach wiring according to initial routing. Fit cable ties in the original positions when installing. Tightening torque l  → Chapter „Assembly overview - exhaust gas temperature regulation “ l  → Chapter „Turbocharger - exploded view“ –  Install air cleaner housing → Chapter.