seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing the Exhaust gas temperature sender 4G648 in vehicles with manual gearbox > < Removing and installing exhaust gas temperature sender?1G235

Leon Mk1

Removing and installing exhaust gas temperature sender 3G495
Removing and installing exhaust gas temperature sender 3 -G495-
t  Removing → Anchor
t  Fitting → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Wrench kit 17 mm -T10395-, see equivalent → Anchor
  W00-10767
Removing
–  Remove engine cover panel -arrows-.
–  Remove air cleaner housing → Chapter.
  E10-10127
–  Take electrical connector -3- out of bracket.
–  Unplug electrical connector -4- and move clear.
–  The exhaust gas temperature sender 3 -G495--Pos. 2-.
  Note
Ignore -item 1-.
Installing
Reassembly is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Exhaust gas temperature regulation“
  Caution
Risk of malfunctions caused by improperly secured exhaust gas temperature senders.
The threads of the exhaust gas temperature senders -G495- and -G648- are coated. It is important that you do NOT grease them additionally with high-temperature paste and that you tighten them to the specified torque.
  Caution
Attach wiring according to initial routing.
Fit cable ties in the original positions when installing.
  A26-11023

Removing and installing the Exhaust gas temperature sender 4G648 in vehicles with manual gearbox > < Removing and installing exhaust gas temperature sender?1G235