Leon Mk1
|
| 1 - | Air duct hose to the charged air cooler on the right side |
| 2 - | Pulsation damper |
| 3 - | Oil return pipe |
| 4 - | Bolt. |
| q | 9 Nm. |
| 5 - | Seal |
| q | Replace |
| 6 - | Threaded connection |
| q | 40 Nm. |
| 7 - | Seal |
| q | Replace |
| 8 - | Bolt. |
| q | 20 Nm. |
| 9 - | Turbocharger |
| q | Can only be renewed together with vacuum unit |
| q | Removing and installing → Chapter. |
| 10 - | Seal |
| q | Replace |
| 11 - | Nut |
| q | Replace |
| q | Coat thread with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| q | 24 Nm. |
| 12 - | Diesel particulate filter with catalytic converter |
| q | Removing and installing the particulate filter in vehicles with manual gearbox → Chapter |
| q | Removing and installing the particulate filter in vehicles with automatic gearbox → Chapter |
| 13 - | Exhaust gas temperature sender 1 -G235- |
| q | Removing and installing → Chapter. |
| 14 - | Banjo bolt |
| q | 30 Nm. |
| 15 - | Oil supply line |
| q | Check for continuity. |
| q | Before installing, fill turbocharger with engine oil at connection for oil supply line |
| q | Tighten union nuts to 22 Nm. |
| 16 - | Bolt. |
| q | 9 Nm. |
| 17 - | Oil seals |
| q | Replace |
| 18 - | Exhaust manifold |
| q | Removing and installing → Chapter. |
| 19 - | Nut |
| q | Replace |
| q | Coat thread with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| q | 24 Nm. |
| 20 - | Vacuum hose |
| 21 - | Flexible hose |
| q | For crankcase ventilation. |
| q | Equipment version for countries with cold climates: With heater element for crankcase breather -N79- |
| 22 - | Air pipe |
| 23 - | Support |
| q | For turbocharger |
| 24 - | Bolt. |
| q | 40 Nm. |
| 25 - | Bolt. |
| q | 9 Nm. |
