SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain) >
< SpannerT20042
Leon Mk1
Power unit
4 cylinder 2.0 litre 4V Common rail TDI engine (2nd generation)
Ignition system, glow plug system
Pre-heating system
Removing and installing engine speed senderG28
Removing and installing engine speed sender -G28-
t
Removing
→ Anchor
t
Fitting
→ Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Extractor -T10118-, see equivalent
→ Anchor
Removing
–
Remove pump for exhaust gas recirculation cooler -V400-
→ Chapter
.
–
Unplug electrical connector at engine speed sender -G28-
-1-
using assembly tool -T10118-.
–
Move electrical wiring clear.
–
Screw out the screw of the engine speed sender -G28-.
Installing
Reassembly is carried out in the reverse order; note the following:
–
Install pump for exhaust gas recirculation cooler -V400-
→ Chapter
.
l
Tightening torque
→ Chapter „Pre-heating system: Assembly overview“
Power unit
4 cylinder 2.0 litre 4V Common rail TDI engine (2nd generation)
Ignition system, glow plug system
Pre-heating system
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain) >
< SpannerT20042