Leon Mk1
Assembly overview - crankcase |
1 - | cylinder block |
q | Removing and installing sealing flange and flywheel → Chapter. |
q | Removing and installing crankshaft → Chapter. |
q | Dismantling and assembling pistons and conrods → Chapter |
2 - | Seal |
q | Replace |
3 - | Oil filter bracket |
q | Dismantling and assembling → Chapter. |
4 - | 15 Nm + 90° (1/4 turn) further |
q | Replace |
q | Firstly position the upper left bolts and lower right bolts then tighten in stages diagonally |
5 - | Spring retainer |
6 - | 20 Nm |
7 - | Joint mouth |
q | For thermostat |
8 - | 15 Nm |
9 - | O ring |
q | Replace |
10 - | Coolant thermostat: |
q | Observe installation position, Removing and installing thermostat → Chapter. |
q | Check: heat the thermostat in water |
q | Starts opening at approx. 85 ℃ |
q | Ends at approx. 105 °C. |
q | Opening lift at least 7 mm. |
11 - | 25 Nm |
12 - | 45 Nm |
q | Observe tightening sequence → Fig.. |
13 - | Spring retainer |
q | For alternator and air conditioner's compressor |
14 - | Poly V-belt tensioning element |
15 - | Oil pan |
q | Clean sealing surface before installing |
q | Fit with → Parts catalogue |
16 - | 15 Nm |