Leon Mk1
Toothed belt drive - exploded view |
1 - | Upper protection element for the notched belt |
2 - | 100 Nm |
3 - | 25 Nm |
4 - | Cogwheel for timing belt |
5 - | Hub |
q | With generator wheel |
q | Use counterholdl -T10051- to loosen and tighten. |
q | For removal use the extraction tool -T10052A- |
q | removing and fitting → Chapter |
6 - | 10 Nm |
q | Replace |
7 - | Stud |
q | 15 Nm |
8 - | Rear notched belt guard |
9 - | 25 Nm |
10 - | Sealing plug |
q | Replace if damaged |
11 - | 20 Nm + 45° (1/8 turn) further |
q | To avoid significant damage to the engine apply correct tightening torques |
12 - | Tensioning roller |
q | The engine support must be removed for the removal and installation |
13 - | 20 Nm |
14 - | Guide roller |
15 - | Coolant pump |
q | removing and fitting → Chapter |
16 - | Crankshaft cogwheel |
17 - | 120 Nm + 90° (1/4 turn) further |
q | Replace |
q | Do not oil or grease the screw thread and the collar further |
q | Turning further can be done in several stages. |
18 - | 15 Nm |
19 - | Toothed belt cover (bottom) |
20 - | Belt pulley and vibration damper |
q | Fitting is only possible in one position, the holes are arranged asymmetrically |
21 - | 10 Nm + 90° (1/4 turn) further |
q | 4x |
q | Replace |
22 - | Cap |
23 - | Control toothed belt |
q | Mark direction of rotation before removing. |
q | Check for wear |
q | Do not bend |
q | Removing, installing and tensioning → Chapter. |
24 - | 45 Nm |
q | Replace |
25 - | Notched belt guard - centre part |
26 - | Engine cross member |