t
| Centre guide -T10134-, see equivalent → Anchor |
t
| Torque wrench kit -SAT 8010-, see equivalent → Anchor |
t
| Three hexagonal bolts -M6 x 35 mm- |
t
| Two hexagonal bolts -M7 x 35 mm- |
t
| Push the sealing flange out with sender wheel → Chapter. |
t
| Insert by pressing sealing flange with the sender wheel → Chapter. |
–
| A - Fitting the sealing flange with sender wheel on the centre guide -T10134- → Anchor. |
–
| B - Fit the centre guide -T10134- with the sealing flange on the crankshaft flange → Anchor. |
–
| C - Bolt the centre guide -T10134- to the crankshaft flange → Anchor. |
–
| D - Press the sender wheel with the fitting device -T10134- on the crankshaft flange → Anchor. |
–
| E - Check the fitting position of the sender wheel on the crankshaft → Anchor. |
–
| F - Rectify the position of the sender wheel → Anchor. |
|
|
|