Leon Mk1
Sealing flanges and flywheel: Assembly overview |
1 - | Oil seal |
q | Do not grease or oil the seal lip of the seal |
q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
q | Renewing crankshaft oil seal on pulley end → Chapter |
2 - | Sealing flange on the pulley side |
q | Must sit on dowel sleeves |
q | removing and fitting → Chapter |
q | Fit with silicon-based sealant → Parts Catalogue → Chapter |
3 - | cylinder block |
q | Removing and installing crankshaft → Chapter. |
q | Dismantling and assembling pistons and conrods → Chapter |
4 - | 60 Nm + 90° (1/4 turn) further |
q | 6 off |
q | Replace |
5 - | Flywheel |
q | removing and fitting → Chapter |
6 - | Intermediate plate |
q | Must sit on dowel sleeves |
q | Do not damage or bend when assembling. |
7 - | 15 Nm |
q | Replace |
8 - | Sealing flange with sealing ring |
q | Only replace the unit complete with the sealing ring and sender wheel |
q | removing and fitting → Chapter |
9 - | Engine speed sender -G28- |
q | Unfasten and tighten with a conventional Allen key with spherical head. |
q | Tightening torque: 5 Nm |
q | removing and fitting → Chapter |