–
| Unbolt the temperature sender after the particulate filter -G527--1- using the articulated wrench E/C 17 -T20212-. |
Install in the reverse order from removal, remembering the following: |
t
| The thread on the new senders is coated with a special paste; the paste must not get into the slots on the probe body |
t
| When reusing the old sender, lubricate the thread with high-temperature lubricant; the paste must not get into the slots on the probe body; high-temperature lubricant → Parts catalogue. |
t
| When assembling, the sender cable must be fixed in its original position to avoid contact with the exhaust pipe. |
|
|
|