SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power unit | 4 cylinder Diesel engine (1.9l TDI) | Fuel supply, gas operation | Fuel supply parts: Removing and installing

Removing and installing fuel cooler

t	Removing → Anchor

t	Installing → Anchor

Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Torque wrench kit -SAT 8010-, see equivalent → Anchor

Removing

Observe rules for cleanliness → Chapter.

Note

The fuel radiator is located on the fuel return tube to the fuel tank. It is fitted low down in the vehicle.

–	Separate the under body covering.

–	Remove the cover -A- (if one is fitted).

–	Disconnect the fuel tubes on the fuel radiator.

–	Remove nuts -arrows-.

Installing

Install in reverse order to dismantling, noting the following:

–	Tighten the radiator bolts to a torque of 15 Nm.

SEAT Workshop Service and Repair Manuals