SEAT Workshop Service and Repair Manuals

Removing and installing coolant temperature sender -G62- t  Removing → Anchor t  Installing → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Release lever -80 - 200-, see equivalent → Anchor

Removing l  Engine cold. –  Open filler cap on coolant expansion tank briefly and allow residual pressure in cooling system to dissipate.

–  Remove the engine cover upwards -arrows-.

–  Fit the centre noise insulation -fasteners 1 ... 3-. –  Remove the air filter housing → Chapter.

–  Remove bolts -arrows-. –  Free electrical lines and hoses on left air pipe using removal lever -80 - 200-. –  Loosen hose clip -3- and press left air pipe with coolant pipe aside.   Note Disregard items -1-, -2-, -4- and -5-.

–  Pull connector -4- off coolant temperature sender -G62-.   Note Place a cloth underneath connection to catch escaping coolant. –  Pull off retaining clip -3- and pull coolant temperature sender -G62- out of screw connection.   Note Ignore positions -1- and -2-. Installing Installation is carried out in reverse sequence; note the following:   Note t  Renew O-ring. t  Insert new coolant temperature sender -G62- immediately into union to avoid loss of coolant. –  Check coolant level and top up if necessary → Chapter.