–
| Place the Drip tray -VAS 6208- under the separation area. |
–
| Remove the coolant hose, the hose clip -1- must be replaced for this purpose. |
–
| Place the used oil collection and extraction unit -SAT 1100- below engine. |
–
| Unscrew bolts -arrows- and remove oil filter bracket with engine oil cooler. |
Installation is carried out in reverse order, noting the following: |
Note t
| Replace the gaskets, seals and O-rings. |
t
| Hose connections and air pipes and hoses must be free of oil and grease before assembly. |
–
| Mount air intake hoses with screw clamps → Fig.. |
–
| Install the oil filter cartridge, top up with engine oil and check level → Booklet101. |
–
| Replenish coolant in cooling system, change coolant if engine oil cooler has been renewed → Chapter. |
|
|
|