Leon Mk1
|
1 - | cylinder block |
q | Removing and installing sealing flange and flywheel → Chapter. |
q | Removing and installing crankshaft → Chapter. |
q | Dismantling and assembling pistons and conrods → Chapter |
2 - | Seal |
q | Replace |
3 - | Oil filter bracket |
4 - | 15 Nm and then turn 90° further |
q | Replace |
q | First fit upper left and lower right bolts and then tighten all four bolts diagonally. |
5 - | Spring retainer |
6 - | 10 Nm |
7 - | Joint mouth |
q | For thermostat |
8 - | 15 Nm |
9 - | O ring |
q | Replace |
10 - | Coolant thermostat: |
q | Observe installation position, Removing and installing thermostat → Chapter. |
q | Check: heat the thermostat in water |
q | Starts opening at approx. 85 ℃ |
q | Ends at approx. 105 ℃. |
q | Opening lift at least 7 mm. |
11 - | 20 Nm and then turn 180° further |
12 - | Spring retainer |
q | For ancillaries |
q | removing and fitting → Chapter |
13 - | 40 Nm and then turn 45° further |
q | Replace |
14 - | Poly V-belt tensioning element |
15 - | Oil pan |
q | Clean sealing surface before installing |
q | Install with silicone sealant -D 176 404 A2-. |
16 - | 15 Nm |