–
| Connect the Vehicle Diagnosis, Testing and Information System -VAS 5051/- as follows: |
–
| Connect the 5m. cable -VAS 5051/6A- to the diagnostic connection. |
–
| Start engine and run at idling speed. |
Only when engine does not start: |
–
| Press button on display for „Vehicle self-diagnosis“. |
–
| Press button „01 - Engine electronics“ on display. |
The display indicates the control unit identification and the coding of the engine control unit. |
Select diagnostic function |
–
| Press „02 - Read fault memory“ button on the display. |
–
| If no fault is stored in engine control unit „0 fault(s) detected“ is displayed. |
–
| If faults are stored in the engine control unit, they are shown one below the other on the display. |
–
| Press „05 - Delete fault memory“ button on the display. |
–
| Press „06 - End output“ function. |
|
|
|