SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power unit | 4 cylinder Direct injection engine, turbocharger | Fuel supply, gas operation

Removing and installing activated charcoal filter

Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Base -T20174-, see equivalent → Anchor

t	Torque wrench (5... 50 Nm) -V.A.G 1331-, see equivalent → Anchor

Activated charcoal filter system: Removing → Anchor

Activated charcoal filter system: Fitting → Anchor

Removing

Note

t	Note safety precautions before starting work → Chapter

t	Observe rules for cleanliness → Chapter.

–	Disconnect the vacuum pipe -1- to the active carbon filter (by pressing the release tab).

Note

The fuel supply lines -2- remain connected.

–	Remove the pipe -1- from the active carbon filter, (the other pipe is permanently connected).

–	Extract the active carbon filter from its support by pulling upwards -arrow-.

Installing

Install in reverse order to dismantling, noting the following:

Note

Secure all hose connections with original clamps.

SEAT Workshop Service and Repair Manuals