Leon Mk1
Sealing flange and flywheel - Assembly overview |
1 - | cylinder block |
2 - | Sealing flange with sealing ring |
q | Removing and installing → Chapter |
q | Replace only completely. |
q | Do not lubricate/grease sealing lip of oil seal |
q | Use support sleeve supplied when fitting |
q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
3 - | Bolt. |
q | Tightening sequence → Fig. |
4 - | Flywheel |
q | For slackening the securing screws, lock using the counterhold -10 201-. |
5 - | Bolt. |
q | 60 Nm and turn 90° further |
q | Replace |
6 - | Needle bearing (dependent on version) |
7 - | Intermediate plate |
q | Must sit on dowel sleeves |
q | Do not damage or bend when assembling. |
q | Is suspended on the gasket → Fig. |
8 - | Dowel sleeve |
|
|