SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power unit | 4 cylinder engine 1.8 litre, 2.0 litre 4V Turbo with petrol direct injection | Enginecrankshaft group, pistons | Cylinder block (gearbox end)

Removing and installing flywheel

t	Removing → Anchor

t	Installing → Anchor

Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter

Special tools and workshop equipment required

t	Hose clamp -10 201-, see equivalent → Anchor

Removing

l	Gearbox removed.

–	Attach the counterhold tool -10 201- before loosening bolts.

Caution

Risk of damaging the outer surface of the mounting flange for the flywheel.

Use a multi-point socket bit with a length of at least 40 mm to slacken and tighten the bolts of the flywheel.

–	Unscrew the bolts and take off flywheel as well as the sender wheel.

Installing

Installation is carried out in the reverse sequence; note the following:

l	Tightening torque → Chapter

Note

t	Renew bolts for flywheel.

t	A needle bearing is fitted in the flywheel. Before installing, check that the needle bearing is fitted. Move the needle bearing of the flywheel in and out with force → Chapter.

–	Pay attention to dowel pin when installing flywheel.

–	Fit counterhold tool -10 201- the other way round to tighten bolts.

SEAT Workshop Service and Repair Manuals