seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing sealing flange (gearbox end) > < Removing and installing flywheel

Leon Mk1

Needle bearing for flywheel: Disengaging and engaging (vehicles with automatic gearbox)
Needle bearing for flywheel: Disengaging and engaging (vehicles with automatic gearbox)
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Pipe section -VW 418A-, see equivalency → Anchor
  W00-0367
t  Hose -VW 421-, see equivalent → Anchor
t  Pressure plate -40 103-, see equivalency → Anchor
  W00-0039
Operation process
l  Gearbox removed.
–  Remove flywheel → Chapter.
–  To drive the flywheel in and out, mount the pressure disc -40 103- at the bottom.
–  Drive out the needle bearing using the tube -VW 421- and workshop press.
l  The thinnest Ø side of the piece of pipe -VW 421- should point to the pressure disc -40 103-.
  A13-10505
–  Carefully drive in the needle bearing as far as stop, using the tube -VW 418A- and workshop press.
l  Fitting position: closed side of needle bearing faces engine.
–  Install flywheel → Chapter.
  A13-10506

Removing and installing sealing flange (gearbox end) > < Removing and installing flywheel