SEAT Workshop Service and Repair Manuals

Separating centre and rear silencers t  The connecting pipe can be cut through at the cutting location in order to renew the centre or rear silencer separately. t  Cutting location is marked by an indentation on circumference of exhaust pipe. Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter Special tools and workshop equipment required

t  Chain pipe cutter -VAS 6254-, see equivalent → Anchor Operation process –  Cut through the exhaust pipe at right angle at the position marked by -arrows- using the chain-type pipe cutter -VAS 6254-.

Engines CDHA, CDHB

–  Insert the clamping sleeve -1- centrally to the cutting line.

Engine CDND

–  Position centre of clamps -arrows- over cutting location.

Continued for all engine versions: –  Install clamps so that the bolt ends do not protrude beyond bottom of clamp. l  Fitting position: Bolt connections face forwards. –  Align exhaust system without tension → Chapter