Leon Mk1
Exhaust manifold, front exhaust pipe with catalytic converter and accessories: Components overview |
1 - | Warm air collector plate |
2 - | 10 Nm |
3 - | Lambda probe -G39-, 50 Nm |
q | Only grease thread with “G 052 112 A3”. The “G 052 112 A3” must not reach the probe body grooves |
q | Remove and assemble using the ring wrench set for lambda probes -3337- |
q | In case of leakage, cut out and replace sealing ring |
4 - | Exhaust manifold with precatalyst |
5 - | Gasket |
q | Replace. |
6 - | 25 Nm |
q | Replace. |
7 - | Electrical connector |
q | Four-pin |
8 - | Electrical connector |
q | Four-pin |
9 - | Lambda after catalytic converter -G130-, 55 Nm |
q | Only grease thread with “G 052 112 A3”. The “G 052 112 A3” must not reach the probe body grooves |
q | Remove and assemble using the ring wrench set for lambda probes -3337- |
q | The connector is located under the right hand side vehicle floor housing. |
10 - | Double clamp, 25 Nm |
q | Align exhaust system when it is cold so it is free of stress before tightening clamp |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
11 - | Front tube bridge |
12 - | 23 Nm |
13 - | Forward section of the exhaust tube with catalytic converter |
q | The vibration damper must not be bent more than 10°, otherwise it will be damaged |
14 - | Retaining ring |
q | If this is damaged, replace it |
15 - | 20 Nm |
16 - | 40 Nm |
q | Replace. |
17 - | Bracket |
18 - | Cable guide |
|