seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Engine lubrication > < Cylinder head
Removing and installing camshaft
Removing and installing camshaft
Removing → Anchor.
Installing → Anchor.
   
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
t  Socket -T40080-, see equivalent → Anchor
t  Camshaft clamp -T10252-
t  Locking bolt -T10115-
t  Double pivot wrench -T10020-, see equivalent → Anchor
t  Torque wrench -V.A.G 1332-, see equivalence → Anchor

removing
–  Disassemble the high pressure pump → Chapter.
–  Remove cylinder head cover → Chapter
   
–  Remove the hoses -1 and 2-, loosen the bolt -3- and detach the coolant hose from the heat-insulating plate.
  A21-10042
–  Loosen the cable support -arrow-.
  N15-10164
–  Remove the variator cover -arrows-.
  N15-10108
–  Make the mark on the camshaft sproket and the mark on the notched belt guard coincide. The concavities -arrows- now face each other perpendicularly.
  N15-10109
–  Position the camshaft fastener -T10252-, as shown in the figure, and tighten it -arrows-.
–  Loosen the securing bolt of the variator using the socket -T40080-.
  N15-10151
–  Compress the chain tensioning device -arrow A-, and lock using the pin -T10115--arrow B-.
–  Loosen the securing bolt of the variator, and remove it together with the chain.
Fitting
  N15-10152
l  The camshafts are fitted using the camshaft fastener -T10252-.
–  Place the chain onto the variator.
  N15-10151
–  Position the variator facing the exhaust camshaft, ensuring that mark -A- and shaft -B- are aligned.
  N15-10121
–  Fit the chain in this position, first at the top -arrow- onto the intake camshaft gear.
  N15-10149
–  Turn the intake camshaft slowly with the double pivot wrench -T10020- in the direction of the arrow -A- until the variator adapts to the camshaft.
  Note
If the bolt does not sit in the well: remove the chain off and hang up again.
–  Tighten the securing bolt of the variator to 100 Nm. To do so, use the socket -T40080-.
  N15-10150
–  Remove the pin -T10115--arrow B-.
Continue installation following reverse order for removing.
–  Fitting the high pressure pump → Chapter.
  N15-10152

Engine lubrication > < Cylinder head