SEAT Workshop Service and Repair Manuals

Removing and installing fuel gauge sender 2 -G169- removing → Anchor Fitting → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Rotation tool -T10202-

t  Torque wrench (5 - 50 Nm) -V.A.G 1331-, see equivalent → Anchor l  The fuel tank should be at half capacity at the most.   Note t  Make sure you do not bend the fuel level gauge sensor. t  If necessary, drain the tank → Chapter. t  Observe the safety precautions before starting work → Chapter. t  Observe rules for cleanliness → Chapter. removing –  First check whether a coded radio is fitted. Check the anti-theft code in this case. –  With the ignition switched off, disconnect the battery earth lead → Electrical system; Rep. Gr.27. –  Remove the seat base → Bodywork, interior fitting work; Rep. Gr.72. –  Dismount the cover of the fuel level sender 2 -G169-, left side looking in the direction of drive. –  Detach connectors .

–  Open the lock ring with the turning tool -T10202- .

–  Pull fuel level sender 2 -G169- lightly upwards and remove the suction pump. Fitting   Caution Do not bend the floater arm of the fuel level sender 2 -G169- during fitting. –  Place the fuel level sender 2 -G169- in the fuel tank.

–  Once inside the fuel tank, place the suction pump over the sender. The clips should engage. –  The new (dry!) Use seal for sealing flange into the opening of the fuel tank and only dampen the inside (contact surface to the flange) with fuel. –  Respect the fitting position of the fuel level sender 2 -G169- → Fig. –  Check the correct position of the reserve.

–  Tighten the lock ring with the turning tool -T10202- . Tightening torque: 110 Nm. –  Attach the connectors . –  Fit the cover. –  Remove the seat base → Bodywork, interior fitting work; Rep. Gr.72.