SEAT Workshop Service and Repair Manuals

Removing and installing cylinder head cover t  Removing → Anchor t  Installing → Anchor t  Tightening torques → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent → Anchor

t  Extractor -T40039-, see equivalent → Anchor Removing –  Remove engine cover. → Chapter Vehicles with engine codes BWJ, CDLD, CDLA –  Remove the air circulation duct on the turbo-charger → Item

Continued for all vehicles –  Unscrew bolts -arrows-. –  Remove the ignition coils with output stages → Chapter.

–  Release the activated carbon filter hose -2- from the cylinder head cover. –  Release the engine block breather hoses -3 and 4- from the cylinder head cover.

–  Loosen the engine block breather hose with heat shield from the turbocharger -1-. –  Release the engine block breather hose -2- from the cylinder head cover, and remove it. –  Release the activated carbon filter hose which leads to the turbocharger from the cylinder head cover -3-. –  Release the cylinder head cover from the outside inwards. –  Remove cylinder head cover. Installing Installation is carried out in the reverse order; noting the following in the process:   Note Replace gaskets for cylinder head cover if damaged. –  Tighten the cylinder head cover in several stages, starting from the inside outwards. –  Ensure that the top guard of the notched belt is correctly seated.

Tightening sequence for cylinder head cover Tightening torques

Qty.	Nm
Cylinder head cover to cylinder head	10
Notched belt guard to engine block	10 → Remark
Variable distribution adjustment housing to cylinder head cover	10

1)  Insert with locking fluid.