Leon Mk1
Part I: |
1 - | Seal |
q | Replace |
2 - | 20 Nm |
q | Replace |
q | Lubricate studs of exhaust manifold with high-temperature lubricant. |
q | Locking fluid for hot working bolts → Parts catalogue |
3 - | 35 Nm |
4 - | Seal |
q | Replace |
5 - | 9 Nm |
6 - | 23 Nm |
q | Only installed when the refrigerant return line is fixed using two brackets. |
7 - | Coolant return hose/pipe |
q | gradual introduction of refrigerant return lines with one bracket |
8 - | Turbocharger |
q | Can only be replaced completely along with the exhaust manifold and the pressure capsule |
q | Removing and installing → Chapter |
9 - | Spring retainer |
10 - | 30 Nm |
q | Apply high-temperature lubricant to bolts |
q | Locking fluid for hot working bolts → Parts catalogue |
11 - | 30 Nm |
q | Apply high-temperature lubricant to bolts |
q | Locking fluid for hot working bolts → Parts catalogue |
12 - | Spring retainer |
13 - | 23 Nm |
14 - | 30 Nm |
q | Do not loosen to remove the turbocharger. |
q | Replace |
q | Lubricate studs of exhaust manifold with high-temperature lubricant. |
q | Locking fluid for hot working bolts → Parts catalogue |
15 - | Fastening strip |