Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
t
For left-hand drive vehicles: Pressure tool -T10238-, see equivalent → Anchor
t
For right-hand drive vehicles: Pressure tool -T10240-, see equivalent → Anchor
Removing
–
Remove the steering column cover -arrows-.
–
Remove the cap -3- by levering with a screwdriver.
–
Undo the securing bolt -2-.
–
Unlock the terminal connector -1--arrow- and remove from the accelerator pedal module.
–
Insert the pressure tool -T10238- (for right-hand drive vehicles, release tool -T10240-) all the way into the corresponding holes, as shown, and remove the accelerator pedal module.
–
Disconnect the connector, and remove the wiring of the accelerator pedal module.
Installing
–
Insert the accelerator pedal module onto the attachment bolts -5-.
–
Insert the centring pin -6- into the hole in the vehicle floor.
–
Secure the accelerator pedal module with bolt -2- and fit cap -3-.
–
Plug in the connector -1- on the accelerator pedal module.