seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine lubrication > < Checking distribution timing

Leon Mk1

Using the gaugeVAS 6079, set the engine to the »TDC position«
Using the gauge -VAS 6079-, set the engine to the »TDC position«
Special tools and workshop equipment required
   
t  Gauge -VAS 6079-, see equivalent → Anchor
  W00-1261
t  Adjustment tool -T10170-
–  Remove the upper cover of the distribution chain → Chapter.
  W00-1291
–  Rotate the crankshaft in direction of engine rotation from the top by turning a 24 mm socket for vibration damper until the markings -arrows- are at the top.
–  Remove spark plug from No. 1 cylinder.
  N15-10720
–  Screw dial gauge adapter -T10170/A- into spark plug hole to stop.
–  Insert gauge -VAS 6079- with extension -T10170A/1- as far as the stop and secure using nut -arrow-.
–  Rotate the crankshaft slowly to the maximum deflection of the pin in the direction of engine rotation. Once the maximum deflection of the pin has been reached (reverse point of the pin), the piston is located in the »TDC position«.
  Note
When the crankshaft rotates beyond the »TDC«, the crankshaft must be rotated by approx. 45° against the direction of the engine again. Then turn the crankshaft in the direction of rotation of the engine until it reaches the »TDC position«.
  N15-10717

Engine lubrication > < Checking distribution timing