Leon Mk1
Oil filter and oil cooler - exploded view |
1 - | Bracket for ancillary mechanical units |
q | Removing and installing → Chapter. |
2 - | Oil pressure switch -F22- |
q | Blue insulation |
q | Removing and installing → Chapter. |
q | check → Vehicle diagnostic tester |
q | 20 Nm. |
3 - | Oil pressure switch for reduced oil pressure -F378- |
q | Brown insulation |
q | Removing and installing → Chapter. |
q | check → Vehicle diagnostic tester |
q | 20 Nm. |
4 - | Seal |
q | Replace |
5 - | O ring |
q | Not available as replacement part, supplied together with valve unit |
6 - | O ring |
q | Not available as replacement part, supplied together with valve unit |
7 - | Valve unit |
q | With O-rings |
8 - | Oil filter |
q | 22 Nm. |
q | Removing and installing → Booklet101. |
q | Remove and install with oil filter tool -3417- |
9 - | Bolt. |
q | 15 Nm. |
10 - | Thrust piece |
11 - | Seal |
q | Replace |
12 - | Oil cooler |
q | See note → Chapter |
q | Ensure clearance from surrounding components |
q | Coolant hose schematic diagram → Chapter. |
q | Removing and installing → Chapter. |
13 - | Seal |
q | Replace |
14 - | Bolt. |
q | Tightening sequence → Fig. |