Parts of lubrication system |
Note t
| Finding metal shavings or a large quantity of small metal particles during engine repair could indicate that the conrod bearings are damaged. To prevent this from causing further damage, perform the following repairs: |
t
| Thoroughly clean oil channels. |
t
| Replace the oil cooler, |
t
| Replace the oil filter. |
t
| The oil level must not be above the max. mark - danger of damaging catalytic converter! |
Oil tray and oil pump - Assembly overview → Chapter |
Coarse oil separator: Removing and installing (engine code BYT) → Chapter |
Coarse oil separator: Removing and installing (engine codes BZB, CCZB - CDAA) → Chapter |
Lower element on the oil tray: Removing and installing → Chapter. |
Remove and install the upper element of the oil tray → Chapter |
Valve for oil pressure control -N428-: Removal and installation (engine codes CCZB - CDAA) → Chapter |
Oil filter and oil cooler: Assembly overview (engine code BYT, BZB) → Chapter |
Oil pressure and oil pressure switch: check → Chapter. |
Oil filter and oil cooler: Assembly overview (engine codes CCZB - CDAA) → Chapter |
Oil pressure switch -F22-: removing and fitting → Chapter |
Oil pressure switch for reduced oil pressure -F378-: removing and fitting → Chapter |
Checking oil pressure and oil pressure switch → Chapter. |
|
|
|