SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Ignition system, glow plug system >
< Injection system
Leon Mk1
Power unit
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain)
Exhaust system
Parts of the exhaust system: Removing and installing
Separating centre and rear silencers
Separating centre and rear silencers
t
The connecting pipe can be cut through at the point marked in order to renew the centre and rear silencers separately.
t
The cutting line is marked on the exhaust tube.
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Chain pipe cutter -VAS 6254-, see equivalent
→ Anchor
Operation process
Proceed as follows:
–
Cut the exhaust pipe at the cutting line
-arrow 2-
cutting at a right angle with the tube cutting chain -VAS 6254-.
–
When installing, position clamp
-4-
on the side marks
-1-
and
-3-
.
–
Install clamp so that ends of bolts do not protrude beyond bottom of clamp.
l
The screw joints face downwards.
–
Align the exhaust system so it is free of stress
→ Chapter
.
Tightening torques
Qty.
Nm
Clamp
23
Power unit
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain)
Exhaust system
Parts of the exhaust system: Removing and installing
Ignition system, glow plug system >
< Injection system