SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Separating centre and rear silencers >
< Silencers with suspension elements - Assembly overview (Ibiza)
Leon Mk1
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Exhaust system / Parts of the exhaust system: removing and fitting
Catalytic converter with exhaust pipe, remove and install (Ibiza)
Catalytic converter with exhaust pipe, remove and install (Ibiza)
Catalytic converter with exhaust pipe, remove and install (Ibiza)
Special tools and workshop equipment required
t
Lambda probe open ring spanner set -3337-
t
Torque wrench -V.A.G 1331-
Removing
–
Remove the Lambda probe -G39-
-1-
using Lambda probe open ring spanner set -3337-.
–
Unscrew the upper securing screw for the alternator
-2-
and press the alternator slightly downwards.
–
Unscrew the fastening bolts
-arrows-
and remove the heat protection plate from the turbocharger.
–
Unscrew the securing bolts on the exhaust gas turbocharger
-arrows-
.
–
Separate the under body protection.
–
Unplug connector
-1-
.
–
Remove the Lambda probes after the catalytic converter -G130-
-2-
.
–
Remove securing bolts
-1-
.
–
Remove the suspension
-2-
from bolt.
–
Loosen the fixing screws of the clamping sleeve
-arrows-
and push to rear.
–
Remove the catalytic converter with exhaust pipe downwards.
Installing
Remaining assembly or installation is carried out in reverse order of removal.
Tightening torques
→ Chapter
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Exhaust system / Parts of the exhaust system: removing and fitting
Catalytic converter with exhaust pipe, remove and install (Ibiza)
Separating centre and rear silencers >
< Silencers with suspension elements - Assembly overview (Ibiza)