SEAT Workshop Service and Repair Manuals

Separating centre and rear silencers t  In order to replace the centre and rear silencers separately, the connecting pipe can be cut at the marked point. t  The cutting point is marked on the exhaust tube. Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Chain pipe cutter -VAS 6254-, see equivalent → Anchor

t  Plate work saw -VAG 1523B-, see equivalent → Anchor

Procedure –  Cut the exhaust pipe -arrow 2- with the chain pipe cutter -VAS 6254- or the bodywork saw -VAG 1523B-. –  During assembly, the double clamp -4- must be aligned at the side markings -arrow --1- and -arrow 3-.

–  Install the double clamp so that the bolt end does not project over the double clamp lower edge -arrow-. l  Screw thread must face rear –  Install and adjust without strain, the secondary silencer → Fig. Tightening torques

Component		Nm
Double pipe bracket		25

Aligning rear silencer –  Align the rear silencer so that the measurements -a- are the same.