SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Checking exhaust system for leaks >
< Separating centre and rear silencers
Leon Mk1
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Exhaust system / Parts of the exhaust system: removing and fitting
Installation position and tightening torque of the clamping sleeve
Installation position and tightening torque of the clamping sleeve
Installation position and tightening torque of the clamping sleeve
Note
Gradual introduction of clamp with continuous clip.
Tightening torque and installation position of the clamping sleeve.
Clamp
-A-
with 2 individual clips.
Tightening torque: 25 Nm
Installation dimensions
-a-
5 mm (only for front clamp)
Clamp
-B-
with continuous clip.
Tightening torque: 35 Nm
Installation dimensions
-a-
8.5 mm (only for front clamp)
Installation dimension
-a-
for vehicles with marking
-A-
on front exhaust pipe
1 -
Clamp
2 -
Front exhaust pipe
3 -
Securing nut
4 -
Securing nut
a -
Installation dimension
A -
Marking
Installation position of front clamp
–
Install clamp so that end of bolt
-arrow-
does not extend beyond lower edge of clamp.
l
Threaded connection faces right.
Installation position of rear clamp
–
Install clamp so that end of bolt
-arrow-
does not extend beyond lower edge of clamp.
l
Screw thread must face rear
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Exhaust system / Parts of the exhaust system: removing and fitting
Installation position and tightening torque of the clamping sleeve
Checking exhaust system for leaks >
< Separating centre and rear silencers