Leon Mk1
Assembly overview - ignition system |
1 - | Cable guide |
2 - | 8 Nm |
3 - | Cap |
4 - | Electrical connector |
5 - | Hall sender -G40- |
q | Replace the O-ring. |
q | Fitting location: Cylinder head cover: |
q | removing and installing → Chapter |
6 - | 10 Nm |
7 - | Spark plug connector with ignition cable |
Note the identification on the ignition cable. |
t | D Ignition transformer = ignition cable cylinder 1 |
t | B Ignition transformer = ignition cable cylinder 2 |
t | C Ignition transformer = ignition cable cylinder 3 |
t | A Ignition transformer = ignition cable cylinder 4 |
8 - | Spark plug, 25 Nm |
Note
t | If new spark plugs are assembled, the spark plug connections must be lubricated with the lubricating paste -G 052 141 A2-. This prevents the sealing hose of the spark plug connections from sticking to the spark plug. The lubricating paste must be distributed when the spark plug connections are fitted to the spark plugs → Fig.. |
t | New spark plug cables are already delivered lubricated. |
q | Remove and install using the extractor -T10112 A- and the spark plug socket and extension -3122 B-. |
q | Type and electrode gap → Chapter. |
9 - | Knock sensor 1 -G61- |
q | Fitting location: located underneath cylinder block manifold |
q | removing and installing → Chapter |
10 - | Electrical connector |
11 - | 20 Nm |
q | Tightening torque influences functions of knock sensor |
12 - | Ignition transformer -N152- |
Note the identification on the ignition cable. |
t | D Ignition transformer = ignition cable cylinder 1 |
t | B Ignition transformer = ignition cable cylinder 2 |
t | C Ignition transformer = ignition cable cylinder 3 |
t | A Ignition transformer = ignition cable cylinder 4 |
13 - | Engine speed sender -G28- |
q | Fitting location: On the side of the gearbox beneath the manifold |
q | removing and installing → Chapter |
14 - | 5 Nm |
15 - | 7 Nm |
Note
|