–
| Push extraction hose into fuel tank until marking -arrow- on hose coincides with filler neck. |
Note A ball valve is located at the lower end of filler neck in fuel tank, which must not be damaged by the extraction hose -1-. Therefore, only push the hose in as far as the tape marking -arrow-. |
–
| Drain as much as possible from the fuel tank. |
–
| Carefully extract the suction hose. |
Note t
| When no more fuel is extracted, the tank is emptied just enough for the sender flange to be opened without danger. |
t
| If the fuel tank has to be drained fully, proceed as follows: → Anchor. |
Emptying fuel tank if it is less than 3/4 full |
–
| Fold rear seat forwards. |
–
| Remove cover from fuel delivery unit. |
WARNING Fuel supply line is pressurised. Wear safety goggles and protective clothing to avoid possible injury and skin contact. Before loosening hose connections, wrap a cloth around the connection. Then release pressure by carefully pulling hose off connection. |
|
–
| Separate the plug connection and remove both lines from the fuel supply unit. Also press the release tabs. |
WARNING The fuel pump unit may be removed only with the tank at maximum 3/4 full. Otherwise a large amount of fuel will escape. |
|
|
|
|