Note t
| When installing an exchange cylinder head, all the contact surfaces between the support elements, roller rocker arms and the cams must be oiled before installing the camshaft housing. |
t
| The plastic packing pieces for protecting the open valves must not be removed until immediately before fitting cylinder head. |
t
| When fitting a new cylinder head or cylinder head gasket, drain off all the old coolant and re-fill with new coolant. |
t
| All bearing points and running surfaces must be oiled before assembly. |
t
| Dismantling and assembling intake manifold → Chapter. |
Removing and installing timing chain and drive chain for oil pump → Chapter. |
Removing and installing camshaft housing → Chapter. |
Removing and fitting the cylinder head → Chapter |
|
|
|