Leon Mk1
Cylinder head - Assembly overview |
1 - | Carrier cover |
2 - | 8.5 Nm |
q | 4x |
3 - | Wiring guide |
4 - | Goes to the air filter |
5 - | 10 Nm |
6 - | Hall sender -G40- |
7 - | O ring |
q | If this is damaged, replace it |
8 - | 10 Nm |
9 - | Negative wire |
10 - | Cylinder head bolt |
q | Replace |
q | Follow installation instructions and sequence when loosening and tightening |
11 - | Roller rocker arms |
q | Check roller bearing for ease of movement. |
q | Oil sliding surfaces |
q | ?When installing, secure to support element using securing clip. |
12 - | Supporting element |
q | Do not mix them up |
q | With hydraulic valve clearance compensation. |
q | Oil sliding surfaces |
13 - | Oil pressure switch -F1- from 0.3 ... 0.7 bar, 25 Nm |
q | check → Chapter |
q | In case of leakage, cut out and replace sealing ring |
14 - | Cylinder head |
q | With fitted pins |
q | removing and installing → Chapter |
q | Checking for distortion → Fig. |
q | Sealing surfaces to camshaft housing must be oil and grease free. |
q | If renewed, change coolant in entire system |
15 - | Cylinder head gasket |
q | Replace |
q | Metal gasket |
q | If renewed, change coolant in entire system |
16 - | Attachment rings |
17 - | 20 Nm |
18 - | Camshaft housing |
q | removing and installing → Chapter |
q | Remove old sealant residues |
q | Carefully clean sealing surfaces. They must be oil and grease free. |
q | Coat with D154 103 A1 before fitting. |
q | When installing, fit vertically from above onto studs and dowel pins. |
19 - | 10 Nm + retighten 1/4 turn (90º) |
q | Replace |
|