Leon Mk1
Part I, belt drive - assembly overview |
1 - | 20 Nm |
2 - | Pulley |
q | For coolant pump |
q | Use water pump wrench -V.A.G 1590- to loosen and tighten. |
3 - | 20 Nm + retighten 1/4 turn (90º) |
q | Replace |
4 - | 40 Nm |
5 - | Plate |
6 - | Guide roller |
7 - | Plate |
8 - | Spacer sleeve |
q | Not fitted on all versions |
9 - | Alternator |
10 - | 25 Nm |
11 - | Spacer sleeve |
12 - | Tensioning element |
13 - | Pulley |
q | Removing and installing crankshaft pulley → Chapter |
q | Contact surfaces must be free of oil and grease. |
q | Secure against turning with counterhold -3415- when removing and installing |
q | The turning further angle can be measured with a commercial protractor. |
q | Poly-V belt: removing and installing → Chapter |
14 - | 150 Nm + retighten 1/2 turn (180º) |
q | Replace |
q | Removing and installing crankshaft pulley → Chapter |
q | Contact surface for securing bolt must be free of oil and grease. |
q | Oil threads before inserting. |
q | Secure pulley against turning with counterhold -3415- and -3415/1-. |
q | The turning further angle can be checked using a commercial protractor e.g. Hazet 6690. |