–
| Connect a contact of injector to be tested to battery (+), using test leads from auxiliary measuring set -V.A.G 1594 C--1-. |
–
| Connect 2nd contact of injector to engine earth using auxiliary measuring set -V.A.G 1594 C--2-. |
–
| Activate remote control -V.A.G 1348/3 A- for 30 seconds. |
–
| Repeat the check on all other injectors. To do this use new measuring glasses. |
–
| After all injectors have been activated, place the measuring glasses on a horizontal surface and compare the injected quantity. Specification: 85 - 105 ml per injector. |
When checking the injection quantity, also check the spray pattern. The spray pattern should be the same for all the injectors. |
If the measured values of one or more injectors are above or below the prescribed specifications: |
|
|
|