Leon Mk1
Engines with engine identification codes BGU - BSE - BSF |
1 - | Radiator |
q | Removing and fitting → Chapter |
q | Replace the coolant after replacing the cylinder head gasket |
2 - | Coolant thermostat: |
q | Removing and fitting → Chapter |
q | Check functioning. Heat the thermostat in water The tip of the thermocouple must start the opening at approx. 87 °C and complete it at approx. 102 °C) |
t | Minimum opening distance 7 mm |
3 - | Coolant pump |
q | Removing and fitting → Chapter |
4 - | Cylinder head/cylinder block |
q | Replace the coolant after replacing the cylinder head gasket |
5 - | Expansion tank |
q | With seal plug |
q | Check the pressure relief valve in the plug using the cooling system tester -SAT 1274- and the adapter -VAG 1274/9- → Anchor |
6 - | Intake manifold with throttle valve connection heating |
7 - | Heat exchanger for heater |
q | Replace the coolant after replacing the cylinder head gasket |
8 - | Oil cooler |
q | For engines with identification letters BGU only |
q | Removing and fitting → Item |