seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Mixture preparation system, electronic inj.,Gas > < Electronic regulation of engine output, electronic accelerator

Leon Mk1

Fuel filter: Removing and installing
Fuel filter: Removing and installing
t  Removing → Anchor
t  Fitting → Anchor.
t  Installation position → Fig.
Special tools and workshop equipment required
t  Container
  Note
t  Observe the safety precautions before starting work → Chapter .
t  Observe rules for cleanliness → Chapter.
Removing
–  Place drip tray under fuel filter.
  WARNING
Fuel system is under pressure! Before opening the system place a cloth around the connection. Then release pressure by carefully pulling fuel hose from connection. Wear safety goggles and appropriate clothing to avoid injury and contact with skin.
   
–  Pull fuel lines -1-, -2- and -3- off. To do this press release tab.
–  Remove bolt -4-.
–  Detach the fuel filter.
Installing
Installation is carried out in the reverse order of removal while noting the following:
Flow direction is marked on filter housing with arrows.
–  Bleeding fuel system → Chapter.
  A20-1082
installation position
The filter casing pin -2- must fit into the notch -1- of the filter bracket.
Tightening torques:
  A20-1133
Qty.Nm
Fuel filter clamp3

   

Mixture preparation system, electronic inj.,Gas > < Electronic regulation of engine output, electronic accelerator