Lever off the cover -3- using a screwdriver and unscrew the screw -2-.
–
Unlock the terminal connector -1--arrow- and remove from the accelerator pedal module.
–
Insert the pressure tool -T10238- (left-hand drive vehicles) or the pressure tool -T10240- (right-hand drive vehicles) in the space on the accelerator pedal module, as shown in the diagram.-arrow-and remove the accelerator pedal module.
Installing
Installation is carried out in the reverse order of removal while noting the following:
–
Fit terminal connector -1- to accelerator pedal module -4-. Engage the connector -arrow-.
l
The connector should snap into place.
–
Insert the accelerator pedal module into the attachment pins -5-.
–
Fit the centre fastener -6- in the hole on the vehicle floor.
–
Secure the accelerator pedal module using the bolt -2- and fit the cover -3-.