Leon Mk1
|
| 1 - | Fuel filler neck |
| q | with connection for earth cable to body |
| q | Check for secure seating. |
| q | screw tight to the bodywork with 10 Nm |
| 2 - | Lock washer |
| 3 - | Clip |
| 4 - | Heat shield |
| 5 - | 25 Nm |
| q | replace |
| 6 - | Line coupling |
| q | Separate to remove the fuel tank |
| q | Release by pressing in button on line coupling |
| 7 - | Ventilation / breather line |
| q | For the activated charcoal filter in right wheel housing |
| q | Separate to remove the fuel tank |
| q | Release by pressing in button on line couplings |
| 8 - | Seal ring 145 Nm |
| q | Remove and install with wrench -T10202- . |
| q | Check for secure seating. |
| 9 - | Flange on left |
| q | Installation position of flange → Fig. |
| q | Disconnect for removing suction-jet pump → Chapter |
| q | Assembly overview - fuel delivery unit with suction-jet pump → Chapter |
| 10 - | Fuel tank |
| q | When removing, support with the engine and gearbox crane -V.A.G 1383 A- |
| q | Removing and installing → Chapter. |
| 11 - | Securing strap (left-side) |
| q | Note fitting position: |
| q | Check for secure seating. |
| 12 - | Securing strap (right-side) |
| q | Note fitting position: |
| q | Check for secure seating. |
| 13 - | Metering pump -V54- |
| q | For auxiliary heater |
| 14 - | Breather line |
| q | From activated charcoal filter solenoid valve 1 -N80- |
| q | to active carbon reservoir |
| q | Separate to remove the fuel tank |
| q | Release by pressing in button on line couplings |
| q | Check for secure seating. |
| 15 - | Fuel pump control unit -J538- |
| q | To remove, first lower fuel tank |
| 16 - | Fuel filter: |
| q | With integrated 6.4 bar pressure limiting valve |
| q | Fitting position: The arrow indicates the direction of flow |
| q | Removing and installing → Chapter. |
| 17 - | Fuel delivery unit |
| q | With fuel level indicator sensor -G- |
| q | Installation position of flange → Fig. |
| q | Assembly overview - fuel delivery unit with suction-jet pump → Chapter |
| q | Removing and installing → Chapter. |
| 18 - | Seal ring 145 Nm |
| q | Remove and install with wrench -T10202- . |
| q | Check for secure seating. |
|
|
