seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine cylinder head, valve gear > < Crankshaft dimensions

Leon Mk1

Fitting
Fitting
  Note!
Do not oil the sealing lip or the edge of the oil seal.
–  Slide oil seal over guide sleeve -T20081B/4-.
   
–  Fit the assembly onto the pivot of the crankshaft.
–  Use guide sleeve -T20081B/1- and press guide sleeve-oil seal assembly as far as it will go until the seal is flush. For this use the used attachment bolt for the crankshaft toothed belt cog wheel.
–  Remove guide sleeve -T20081B/4-.
  E13-0147
–  Fit the crankshaft cog wheel for the toothed belt using the locking tool -T20018A-.
–  Tighten the new centre bolt to a torque of: 90 Nm + 1/4 turn (90°).
  Note!
Thread and shoulder must be free of oil and grease.
–  Fit the notched belt → Chapter.
  E13-0016

Engine cylinder head, valve gear > < Crankshaft dimensions