On new conrods it is possible that the breaking point is not fully separated. If it is not possible to take off the conrod bearing cap by hand, proceed as follows:
–
Mark the conrod correspondence to the cylinder → Item.
–
Gently clamp conrod, as shown in illustration, in a vice with soft aluminium jaws.
Note
t
Secure the conrod slowly so that it does not break.
t
The conrod is attached below the cutting line.
–
Unscrew the two bolts -arrows-. approx. 5 turns.
–
Using a plastic hammer, carefully knock conrod bearing cap loose in direction of -arrow-.