SEAT Workshop Service and Repair Manuals

Removing and installing the temperature sender after particulate filter -G527-, engine code BLS t  Removing → Anchor t  Installing → Anchor t  Tightening torques → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Articulated wrench e/c 17 -T20212-, see equivalent → Anchor

t  Torque wrench kit -SAT 8010-, see equivalent → Anchor

Removing –  First remove the outer cover -1- and then the inner cover -2- upwards equally.

–  Release the fuel and coolant hoses from their fittings on the air duct. –  Remove bolt -1-. –  Remove air duct by lifting retaining clips -arrows- slightly.

–  Separate the connector -2- of the temperature sensor after particle filter -G527- and move the cables to one side.

–  Remove central noise insulation -Attachment parts 1 ... 3-.

–  Unbolt the temperature sender after the particulate filter -G527--1- using the articulated wrench E/C 17 -T20212-. Installing Continue the installation in the reverse order of removal sequence, observing the following:   Note Fit the cable clamps in the same position as they were. –  Fit the supercharger air system hoses and observe the assembly instructions → Chapter. Tightening torques

Component	Nm
Temperature sensor after particle filter -G527- to particle filter.	45
Right air hose to bracket	8