–
| Undo the temperature sender before the particle filter -G448--5- using the socket wrench E/C 17 -T20211- and the "ratchet 1/2"" x 9-12" -VAG 1331/1-. |
Continue the installation in the reverse order of removal sequence, observing the following: |
Note Fit the cable clamps in the same position as they were. |
–
| When fitting, ensure that the bend of the exhaust gas temperature sender 2, bedplate 1 -G448--5- faces the left side of the vehicle, as shown in the diagram. |
–
| Fit the supercharger air system hoses and observe the assembly instructions → Chapter. |
|
|
|