seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fuel supply components: Removing and installing. > < Accelerator pedal module with accelerator position sender G79 and Accelerator pedal position sender -2-G185: removal and assembl

Leon Mk1

Fuel cooler: Removing and installing.
Fuel cooler: Removing and installing.
t  Removing → Anchor
t  Installing → Anchor
  Note
The fuel radiator is located underneath in the lower part of the vehicle (right hand side).
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Torque wrench kit -SAT 8010-, see equivalent → Anchor
  L00-10226
Removing
Observe rules for cleanliness → Chapter.
–  Remove right hand side vehicle floor cover -arrows-.
–  Place drip tray under vehicle floor.
  WARNING
t  The fuel system is pressurised. Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection.
t  For those vehicles fitted with an injector pump, the temperature of the fuel and the fuel lines may reach up to 100 ºC in extreme cases. Before opening the duct connections, allow the fuel to cool otherwise there is a risk of severe burns.
t  Wear eye and hand protection when performing any type of repair work on the fuel system!
  A10-1663
–  Extract the fuel pipes from the fuel radiator -arrows-.
–  Unscrew bolts -1- and -3- and take the fuel radiator off -2-.
Installing
Continue the installation in the reverse order of removal sequence, observing the following:
t  Tighten the radiator bolts to a torque of 15 Nm.
  A20-1114

Fuel supply components: Removing and installing. > < Accelerator pedal module with accelerator position sender G79 and Accelerator pedal position sender -2-G185: removal and assembl