seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Tandem pump: repairs > < Safety precautions when working on fuel supply system
Air filter housing: removing and fitting
Air filter housing: removing and fitting
t  Removing → Anchor
t  Fitting → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Counterhold -T20174- or Pliers -T20029-, see equivalent → Anchor
  W00-2456
Removing
Observe safety precautions → Chapter.
Observe rules for cleanliness → Chapter.
Engine cover (version 1):
–  Take out the oil dipstick -1- from its guide tube.
–  Raise the engine cover sideways -arrows 2- and remove it forwards -arrow 3-.
–  Replace the oil dipstick in the guide tube.
  E10-10002
Engine cover (version 2):
–  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.
All vehicles (continued):
  WARNING
t  Fuel system is under pressure! Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection.
t  For those vehicles fitted with an injector pump, the temperature of the fuel and the fuel lines may reach up to 100 ºC in extreme cases. Before opening the duct connections, allow the fuel to cool otherwise there is a risk of severe burns.
t  Wear protection gloves.
t  Wear eye protection.
  E10-10038
–  Pull fuel supply line -2- and return line -1- off. To do this press release tabs.
  A20-1118
–  Disconnect the fuel supply hose -2- (white mark) and return hose -1- (blue marking) from the fuel pipes.
  A10-1684
Fuel filter, version 1:
–  Extract the fuel filter bracket by pulling upwards -arrow- with the hoses connected.
  A10-1685
Fuel filter, version 2:
–  Loosen the bolt by one turn -1-.
–  Unscrew bolt -2- and nut -3-.
–  Leave the fuel filter to one side with the flexible hoses.
Fitting
Installation is carried out in the reverse order, noting the following:
  Note
Secure all hose connections with the correct hose clips (same as original equipment) → Spare parts catalogue.
–  Carefully hook the fuel filter into the bracket.
–  Connect the supply and return hoses onto the fuel filter according to the markings.
  A20-10245

Tandem pump: repairs > < Safety precautions when working on fuel supply system