–
| Remove the attachments from the support frame -arrow- and remove the control unit. |
–
| Fit the new control unit in the support frame and fix it. |
–
| Fit the control unit connectors and block them. |
–
| Check the previous encoding and encode the new control unit → Chapter. |
–
| Adapt the new control unit to the throttle valve control unit → Chapter. |
–
| Adapt the new control unit to the electronic immobiliser → Anchor. |
–
| Finally, consult the fault memory of the new engine control unit and, if necessary, clear the fault memory → Anchor, Fault memory: consulting and clearing |
Note! This operation must be carried out after encoding the new engine control unit and adapting the new unit to the throttle valve drive. |
|
|
|