When checking and assembly work is being carried out, the other control units may find problems, such as, for example, loose connections. Therefore, when the work has finished, the fault memories of all the control units must be consulted and cleared as follows: |
–
| Press 0 twice to enter the direction code “Automatic checking cycle” and confirm with Q. The -V.A.G 1551- unit will successively emit all known directioon codes. |
If the control unit responds with its identification, the display will show the number of faults detected or will give the message “no fault detected”. |
The possible faults memorised in a system are indicated and printed successively. Then the -V.A.G 1551- gives the following direction code. |
|
|
|